Top Cover - HP 3105m Maintenance And Service Manual

Top cover

Description
Top cover
Before removing the top cover, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation mode,
turn on the computer, and then shut it down using the operating system.
2. Disconnect all of the external devices that are connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service cover
6. Remove the hard drive (see
7. Remove the keyboard (see
Remove the top cover:
To remove the top cover, follow these steps:
1. Position the computer upside down on a flat surface, with the front toward you.
2. Use a thin, flat tool to release the 2 rubber feet, and then remove the two screws that are located
under the rubber feet (1).
3. Remove the remaining 8 screws that secure the keyboard to the computer.
4. Position the computer right-side up, with the front toward you and the display open as far as
possible.
5. Lift the rear edge (1) of the top cover until it detaches from the base enclosure.
ENWW
Battery on page 32).
Hard drive on page 33.
Hard drive on page
Keyboard on page 43).
33).
Component replacement procedures
Spare part number
635316-001
45