Table of Contents
Advertisement
Memory modules
Description
2-GB memory module (1333-MHz, DDR3)
Before removing the memory module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation mode,
turn on the computer, and then shut it down using the operating system.
2.
Disconnect all of the external devices that are connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the service cover (see
Remove the memory module:
NOTE:
1024-MB primary memory is included on the system board. Memory is both customer-
accessible and upgradable. It is located in the accessory compartment.
To remove the memory module, follow these steps:
1.
Save your work and shut down the computer.
2.
Disconnect all of the external devices that are connected to the computer.
CAUTION:
the components on the memory module.
3.
Unplug the power cord from the AC outlet.
NOTE:
memory module slot.
4.
Turn the computer upside down on a flat surface and remove the battery.
ENWW
Battery on page
To prevent damage to the memory module, hold it by the edges only. Do not touch
Memory modules are designed with a notch (3) to prevent incorrect insertion into the
32).
Hard drive on page
33).
Spare part number
598856-001
Component replacement procedures
41
Hide quick links:
Advertisement
Table of Contents
