Page 2
Areas with strong vibrations Use a soft cloth to clean the camera. Use pressured air spray to clean the surface of the glass. DO not scratch the surface of the glass. EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
Specifications Electronic specifications / Mechanical specifications / Environmental specifications EV-G030B1 Product EV-G030B1 1/3" interline VGA monochrome Electronic Imager progressive CCD: ICX424AL specifications Total picture elements 692 (H) x 504 (V) VGA: 648 (H) x 494 (V) *EV-G003B1: With respect to the entered size, the 15 pixels above and below, and the 0 to 14th pixels and 633rd to 647th pixels on the left and right sides will be blacked out.
When use this camera, please set up the camera proper way to radiate heat, which is the housing top plate temperature is less than 70 deg. C. The case heat management becomes keep the heat rating of the electronic components of the camera. Temperature measuring point at the housing top plate EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
Note: Recommend to lock down the screw to the camera with 0.18 N・m torque when connect the screw lock LAN cable to the camera Pin assignment Pin No. Signal name Note. Power supply connection comprise PoE (IEEE802.3af). EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
Please check the NIC and HUB setting is “1Gb transferring” when use with 1Gb supported NIC and HUB. When snapping of the CAT5e cable, possibility to change the transferring speed from 1Gb to 100Mb. Please change the CAT5e cable. EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
IO GND 12pin connector Refer Fig. 3 Note.1: All I/Os (Pin number 3 through 10) are user assignable. Note.2: DO NOT connect or disconnect the power/IO connector while the power input though PoE. EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
This TrigerInternal signal is the input trigger signal with the trigger delay time. F) SensorReadOut This SensorReadOut signal is the FVAL signal, which is the image output period of the time. G) StrobeSignal This StrobeSignal signal is the strobe control signal. EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...
DC IRIS lens connector Not available for use with this camera. Pin assignment Pin No. Signal name DAMP- DAMP+ DRIVE+ DRIVE- Fig. 2 DC IRIS lens connector EV-G030B1 / EV-G200C1 / EV-G200B1 Specifications Rev. 1.00...