Power Connector Cable - HP 15 Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery (see
● Service door (see
●
WLAN module (see
● Top cover (see
●
System board (see
To remove the power connector cable:
1. Position the system board upside down.
2. Disconnect the power connector cable (1) from the system board.
3. Release the power connector cable from the clips (2) built into the fan.
Battery on page 49), and then remove the following components:
Service door on page 55)
WLAN module on page
Top cover/keyboard on page
System board on page
58)
61)
83)
Component replacement procedures
Spare part number
747116-001
97