Page 1
User Manual CABLE TESTER CT100 Professional 6-in-1 Cable Tester...
Page 2
Move the ON switch to the CABLE TESTER position. Insert one end of your cable into any OUT jack of the CT100. Connect the other end of the cable to any IN jack. The LEDs will indicate which input pins are connected to each output pin.
To test a cable for short circuits, connect one end of the cable to the appropriate OUT jack of the CT100. The display works as in CABLE TESTER MODE (see chapter 2). However, it now indicates connections between out pins. If no LEDs light, the cable is free of short circuits.
Page 4
CABLE TESTER CT100 User Manual 5. Phantom Power Detect In TEST TONE MODE, pins 2 and 3 are monitored for external DC voltage (commonly supplied for condenser microphones). The PHANTOM LEDs will light if DC voltage above approx. 9 V is detected.
CABLE TESTER CT100 User Manual output input 1 = ground/shield 2 = hot (+ve) 3 = cold (-ve) For unbalanced use, pin 1 and pin 3 have to be bridged XLR connectors (pin numbers visible on connectors) Pin 2 (tip)
Page 6
CABLE TESTER CT100 User Manual FEDERAL COMMUNICATIONS COMMISSION COMPLIANCE INFORMATION CABLE TESTER CT100 MUSIC Group Services US Inc. Responsible Party Name: 18912 North Creek Parkway, Address: Suite 200 Bothell, WA 98011, Phone: +1 425 672 0816 Phone/Fax No.: Fax: +1 425 673 7647 CABLE TESTER CT100 complies with the FCC rules as mentioned in the following paragraph:...