Touch Controls; The Cooktop - GE Digital Radiant Cooktop Owner's Manual

Introduction
A cooling fan will start and run as soon as any
surface unit is turned on. This is to insure safe
and reliable operation of the cooktop. This fan
constantly cools the critical components of the
cooktop. Under certain extreme periods of
usage, this fan may continue to run after you
complete cooking and you turn the cooktop
off. It will continue to cool the cooktop and the
controls until an acceptable temperature is
reached. The fan will then turn itself off.
The touch controls give you precise control of
the surface units. You can quickly switch back
and forth between a steady low heat and full
power or anywhere in between.
1. To turn a surface unit on, touch the
2. To turn a surface unit off, touch the
Be sure to set the correct control for the
surface unit you wish to use.
The cooktop will not turn on if two or
more touch control pads are touched at
the same time.
How to lock
IMPORTANT: As a safety feature, you can
lock the entire cooktop at any time.

the cooktop

To lock the cooktop, press and hold the LOCK
pad for 2 seconds. A signal will sound and the
lock pad will light indicating the cooktop is
locked. To unlock, press and hold the LOCK
pad again for 2 seconds. A signal will sound
and the light will go out, indicating the
cooktop is unlocked.
Locking the cooktop will prevent surface units
from accidentally being turned on by children
or pets.
Always lock the cooktop when it is not in use
and before cleaning.
If the cooktop is locked while surface units are
in use they will automatically shut off.
8
ON/OFF pad and touch the INCREASE
and/or DECREASE pads to choose the
desired heat setting. The control will beep
each time a pad is touched. The display
shows your heat setting.
ON/OFF pad again.

Touch Controls

Digital Radiant Cooktop
Single unit
control
Single unit Dual
control unit control
Indicator Lights—Lights will come on under
the ON , Dual /Single
or the Bridge /Single
touched, to indicate the surface unit or feature
is turned on. The indicator light will go off
when the surface unit or feature is turned off.
Hot Surface Indicator Lights—Each surface
unit has a light that will come on and stay on as
long as the surface unit is too hot to touch.
Lock/unlock
control
Press and hold for two seconds to lock and unlock.
Single/Bridge
unit control
Warmer unit
control
, LOCK
pads when