Connecting Devices To The Unit; Connecting Required Devices - GE 30 User Manual

Connecting devices to the unit

Use Figure 2 below as a visual guide to connect the various peripherals to the TVR 30.
Figure 2: Back panel connection diagram
1
3 4
1. Connect up to two CCTV monitors (main and spot)
and/or Y/C (S-video)
2. Connect up to 16 cameras
3. Connect to speakers for audio output
4. Connect to audio input (available for each camera)
5. Connect to a monitor that displays digital video
(HDMI)
6. Connect to a PTZ control
7. Alarm output
Note: The TVR 30 only supports 800 x 600 resolution in VGA and HDMI. Adjust your
monitor accordingly to this resolution. If looping video, ensure that the Termination
option (Cameras > Adjust Video) is disabled.

Connecting required devices

Before powering up the unit, cameras and a main monitor should be connected to
the unit for basic operation. If needed, connect a spot monitor for displaying full
screen video of all installed cameras in sequence.
TruVision DVR 30 User Manual
2
5 6 7 8 9
8.
9.
10. Connect to USB devices
11. Connect to a network
12. Connect to a point-of-sale (POS) device
13. Connect to VGA monitor
14. Connect to the power cord
10 11 12 13
Link /Act
100
FD/Col
Power
1 2 3 4 5 6 7 8
Connect to alarm input cables
Connect to a network attached storage (NAS) device
(This device is currently not supported)
Chapter 2: Installation
14
7