GE JSP42SKSS Dimensions And Installation Information

JSP42SK
GE 30" Slide-In Electric Range
®
Dimensions and Installation Information
Models are shipped with color-
KW Rating
matched Rear Filler Strip Kit.
240V 11.6
Optional Kits For Slide-In
Electric Ranges
208V
8.7
(Available at additional cost)
Lower/Side Trim Kits Accessory Backguards
JXS56 - Lower Trim Kit
JXS86 - Vertical Side Trim Kit
Note: To reduce possiblity of scorching of the side wall
adjacent to the heating elements, it is recommended
a minimum of 6" spacing from adjacent side walls
be allowed for possible extended, high-heat, no-load
operation of heating elements.
Receptacle Location: For all 30" Slide-In Ranges locally
approved flexible service cord or conduit must be
used because terminals are not accessible after range
installation. See shaded area in drawing for location of
electrical outlet box. Recommended outlet locations
allow range to be installed directly against rear wall.
Note: Cabinets installed adjacent to slide-in ranges
must have an adhesion spec of at least 194°.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
For answers to your Monogram, GE Profile
®
GE appliance questions, visit our website at
®
ge.com or call GE Answer Center
®
800.626.2000.
2-7/8"
To Front
Surface Of
Countertop
JXS37 - Backguard
JXS77 - Body Sides
If you are NOT using the
optional Filler or Backguard:
or
™
service,
2-1/2
7-1/2
2-1/2
30
24
31-1/4
36-1/4
20-5/8" Door
Clearance
From Front
Surface of
Countertop
25-3/4**
(excluding handle)
If you are using the optional
Filler or Backguard:
23-3/16
30
Accessory
Backguard
A/B*
Shave Raised Edge To Clear
31-1/8" Wide Control Panel
30 " Mi n.
Excluding Models JSS28 and JSP39
Recommended
6" Min.
From Walls
30 " Mi n.
Acceptable
23-3/16
Electrical
Outlet Area
*JXS37 is 5-1/4" and JXS32 is 4"
**Total depth from wall to
35-7/8"–38"
front of closed oven door
from floor to
including handle is 27-13/16.
countertop
2-1/2
30
25
24
2-7/8"
To Front
Surface Of
Countertop
30
Dimension and installation information are shown in inches.
20-5/8" Door
Clearance
All GE ranges are equipped with
an Anti-Tip device. The installation From Front
of this device is an important,
Surface of
required step in the installation
Countertop
of the range.
Specification Revised 1/08
9/16
13" Max.
15" Min.
25
7-1/2
2-1/2
Accessory
Backguard
A/B*
31-1/4
36-1/4
Listed by
Underwriters
Laboratories
*JXS37 is 5-1/4" and J
320642
25-3/4**
(excluding handle)
**Total depth from wall
front of closed oven d