Power Outage - GE JGB295 Owner's Manual And Installation Instructions

Using the upper oven.
To avoid possible burns, place the racks in the desired position before you turn the oven on.
Before you begin...
The racks have stop-locks, so that when
placed correctly on the rack supports
(A through E), they will stop before coming
completely out, and will not tilt.
When placing and removing cookware,
pull the rack out to the bump on the rack
support.
Upper Oven Vent
Your oven is vented through ducts at the rear
of the range. Do not block these ducts when
cooking in the oven—it is important that the
flow of hot air from the oven and fresh air
to the oven burner be uninterrupted. Avoid
touching the vent openings or nearby
surfaces during oven or broiler operation—
they may become hot.

Power Outage

CAUTION:
Do not make any
attempt to operate the electric ignition oven
during an electrical power failure.
The oven or broiler cannot be lit during a
power failure. Gas will not flow unless the
glow bar is hot.
Upper Oven Light
Touch the Oven Light pad on the upper
control panel to turn the light on or off.
On some models, the Oven Light switch
is on the lower front control panel.
GEAppliances.com
To remove a rack, pull it toward you, tilt the
front end up and pull it out.
To replace, place the end of the rack
(stop-locks) on the support, tilt up the front
and push the rack in.
NOTE: The rack is not designed to slide out
at the special low rack (R) position.
Handles of pots and pans on the cooktop
n
may become hot if left too close to the vent.
Do not leave plastic or flammable items on
n
the cooktop—they may melt or ignite if left
too close to the vent.
Do not leave closed containers on the
n
cooktop. The pressure in closed containers
may increase, which may cause them
to burst.
Metal items will become very hot if they are
n
left on the cooktop, and could cause burns.
If the oven is in use when a power failure
occurs, the oven burner shuts off and cannot
be relit until power is restored. This is because
the flow of gas is automatically stopped and
will not resume when power is restored until
the glow bar has reached operating
temperature.
13