GE JGB281 Owner's Manual & Installation Instructions page 27

.
Standard Twin Burner Assemblies
For cleaning information on sealed burners,
see section below. Sealed burner cooktops
do not lift up.
On models with standard twin burners,
the cooktop lifts up for easy access.
Turn all controls OFF before removing burner
parts and drip pans (if so equipped).
The burner grates and drip pans (if so
equipped) can be lifted off, making them
easy to clean.
The holes in the surface burners of your
range must be kept clean at all times for
proper ignition and an even, unhampered
flame.
You should clean the surface burners
routinely, especially after bad spillovers,
which could clog these holes.
Wipe off surface burners. If heavy spillover
occurs, remove the surface burners from the
range. Burners lift out for cleaning. Lift up the
cooktop and then lift out the surface burners.
To remove burned-on food, soak the surface
burner in a solution of mild liquid detergent
and hot water. Soak the surface burner for
20 to 30 minutes.
Sealed Burner Assemblies
Turn all controls OFF before removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and
drip pans (if so equipped) can be lifted off,
making them easy to clean.
CAUTION:
Do not operate
the cooktop without all burner parts, drip pans
(if so equipped) and grates in place.
NOTE: Do not lift the cooktop. Lifting the
cooktop on sealed burner models can lead to
damage and improper operation of the range.
(on some models)
For more stubborn stains, use a cleanser like
Soft Scrub brand or Bon Ami
®
well to remove any traces of the cleanser
that might clog the surface burner openings.
Do not use steel wool because it will clog the
surface burner openings and scratch the
surface burners. If the holes become clogged,
clean them with a sewing needle or twist-tie.
Before putting the surface burner back,
shake out excess water and then dry it
thoroughly by setting it in a warm oven
for 30 minutes. Then place it back in the
range, making sure it is properly seated
and level.
Check the flame pattern of each burner.
If the flames are "jumpy" (not steady),
clean the holes again with a sewing
needle or twist-tie.
(on some models)
The electrode of the spark igniter is
exposed when the burner head is
removed. When one burner is turned
to LITE, all the burners spark. Do not
attempt to disassemble or clean
around any burner while another
burner is on. An electric shock may
result, which could cause you to
knock over hot cookware.
GEAppliances.com
brand. Rinse
®
27