Oven Light Replacement - GE JBP56 Use And Care & Installation Manual

General electric self-cleaning electronic range use and care & installation guide
Table of Contents

Advertisement

Lift-Off Oven Door
The oven door is removable,
but it is heavy. You may need
help removing and replacing the
door. Do not lift the door by the
handle. This can cause the glass
the door.
To remove the door, open it a
few inches to the special stop
position that will hold the door
open. Grasp firmly on each side
and lift the door straight up and
off the hinges.
NOTE: Be careful not to place hands between the
hinge and the oven door frame as the hinge could
snap back and pinch fingers.
To replace the door, make sure the hinges are in the
special stop position. Position the slots in the bottom
of the door squarely over the hinges. Then lower the
door slowly and evenly over both hinges at the same
time. If the hinges snap back against the oven frame,
pull them back out.
TO CLEAN THE DOOR:
Inside of the door:
Because the area inside the gasket is cleaned during
the self clean cycle, you do not need to clean this
by hand. Any soap left on the liner causes additional
stains when the oven is heated.
a scouring pad.

Oven Light Replacement

CAUTION: Before replacing your oven light bulb,
disconnect the electri; power for your range at the
main fuse or circuit breaker panel or pull the plug.
Be sure to let the light cover and bulb cool completely
before removing or replacing them. When in use, light
bulbs can become warm enough to break if touched
with a moist cloth or towel. When cleaning, avoid
touching warm lights with cleaning cloths if the light
cover is removed.
The oven light (bulb) is
covered with a removable
glass cover which is held
in place with a wire. Remove ~
the oven door, if desired, to
reach the cover easily.
28
(continued)
1'
Wire cover holder
Do not rub or clean the door gasket—
the fiberglass material of the gasket has an
extremely low resistance to abrasion. An intact and
well-fitting oven door gasket is essential for energy-
efficient oven operation and good baking results.
If you notice the gasket becoming worn, frayed or
damaged in any way or if it has become displaced
on the door, you should have it replaced.
NOTE: The gasket is designed with a gap at the
bottom to allow for proper air circulation.
I
Outside of the door:
Use soap and water to thoroughly clean the top,
sides and front of the oven door. Rinse well. You
may also use a glass cleaner to clean the glass on
the outside of the door.
Spillage of marinades, fruit juices, tomato sauces
and basting materials containing acids may cause
discoloration and should be wiped up immediately.
When the surface is cool, clean and rinse.
not use oven cleaners, cleansing powders or
Do
harsh abrasives on the outside of the door.
To remove:
Hold your hand under the cover so it doesn't fall
when released. With fingers of the same hand,
firmly push back the wire cover holder. Lift off
the cover.
DO NOT REMOVE ANY SCREWS.
Replace bulb with 40-watt home appliance bulb.
To replace cover:
Place it into the groove of the light receptacle. Pull
the wire forward to the center of cover until it snaps
in place. When in place, the wire holds the cover
firmly. Be certain the wire is in the depression in the
center of the cover.
Connect electric power to the range.
Inside Gasket
Gasket
Outside Gasket

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jbp55Jbp58

Table of Contents