Control Panel And Knobs; Painted Surfaces; Metal Parts; Oven Vent - GE JBP56 Use And Care & Installation Manual

Control Panel and Knobs

Clean up any spills or spatters with a damp cloth.
Remove heavier soil with warm, soapy water.
Clean the control panel with mild liquid dish
detergent and a soft cloth. Rub control panel lightly.
CAUTION: Do not use abrasives of any kind on the
control panel. The lettering on models with touch
pads is sensitive to abrasives and pressure.
The control knobs may be removed for easier
cleaning. To remove a knob, pull it straight off
the stem. Wash the knobs in soap and water but
do not soak.
When changing a cooktop light, do not touch the
metal at the ends of the light.
The cooktop light is easily replaced with a fluorescent
tube of the same wattage. Before changing the light,
pull the plug to the range or disconnect the power at
the main fuse or circuit breaker panel.
To remove:
Lift the light cover by pulling the bottom edge
toward you and then up.
Place fingers on top near each end of the light.
Roll the top of the light gently toward the front of
the range and gently pull the light from the socket,
making sure it does not hit the light cover.

Metal Parts

Do not use steel wool, abrasives,
ammonia or commercial oven
cleaners. To safely clean surfaces;
wash, rinse and then dry with a
soft cloth.

Oven Vent

The oven is vented through an opening under the right rear surface unit.
Never cover the opening with aluminum foil or any other material. This
would prevent the oven vent from working properly.
(on some models)
Glass Window
To clean the outside of the oven
window use a glass cleaner. Rinse
and polish with a dry cloth.
To replace:
Place fingers on the top near each end of the light.
Press the light into the slots until it snaps into place.
Move light cover down and snap into place.

Painted Surfaces

Painted surfaces include the
outside oven door, sides, control
panel and drawer front. Clean
these with soap and water or a
vinegar and water solution. Do not
use commercial oven cleaners,
cleansing powders, steel wool or
harsh abrasives on any painted
surface.
1'
Oven Vent
27