Table of Contents
Advertisement
OVEN CONTROL, CLOCK Am T~ER
Clock
The clock must be set for the automatic oven
timing functions to work properly. The time of
Self-Cleaning cycle.
Timer
The timer is a minute timer only.
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 55 minutes.
To Reset the Timer
If "TIMER" is displayed, press the INCREASE or
DECREASE pad until the desired time is reached.
If "TIMER" is not displayed, press the TIMER pad
first. then follow the instructions above to set the timer.
Power Outage
After a power outage, when power is restored, the display will flash and
time shown will no longer be correct—for example, after a 5-minute power
interruption the clock will be 5 minutes slow. All other functions that were
in operation when the power went out will have to be programmed again.
End of Cycle Tone
The end of cycle tone is a series of 3 beeps followed
by 1 beep every 6 seconds. If you would like to
remove the signal that beeps every 6 seconds, press
and hold the CLEAWOFF pad for 10 seconds.
To return the signal that beeps every 6 seconds, press
and hold the CLEAWOFF pad for 10 seconds.
12
To Set the Clock
1. Press the CLOCK pad.
CLOCK
n
2. Press the INCREASE or DECREASE pad to
set the time of day.
3. Press the CLOCK pad to start.
To Set the Timer
1. Press the TIMER ON/OFF pad.
TIMER
ON/OFF
Press the INCREASE or DECREASE pad to set
2.
the amount of time on timer. The timer will start
automatically within a few seconds of releasing
the pad.
The timer, as you are setting it, will display seconds
until 1 minute is reached. Then it will display minutes
and seconds until 60 minutes is reached.
After 60 minutes, it will display hours ("HR"
now appears in the display) and minutes until the
maximum time of 9 hours and 55 minutes is reached.
To Cancel the Timer
Press and hold the TIMER ON/OFF pad until the
word "TIMER" disappears from the display.
Display Messages
If "door" appears in the display, the door latch
handle is not moved all the way to the right. Move
the latch handle and cleaning will start. If "LOCK"
appears in the display, the oven door is in the locked
position. BAKE, BROIL and COOK TIME cannot be
set if the door is in the locked position.
Advertisement
Table of Contents
