Dtip Pans; Drip Pans; Oven Vent - GE JBP22GR Use And Care & Installation Manual

Drip Pans

Surface
To remove the drip pans for cleaning. the surface units
inch above the drip pan and pull it out. Make sure the
surface units are completely cool bejbre touching
them. Clean the drip pans with soap and water, plastic
IN SELF-CLEANING OVEN; pans will discolor.
Wipe after each cooking so unnoticed spatter will not
burn next time you cook.
on the
Cooktop Surface Lamp
When changing a cooktop lamp, do not touch the
metal at the ends of the lamp.
wattage._ Be~"ore changing the lamp,
the range or disconnect the power at the
Lift the lamp cover by pulling the bottom edge toward
top near each end of the lamp.
on
the lamp gently toward the front of the
top of
sure it does not hit the lamp cover.

Oven Vent

The oven is ~ented through an opening under the right
rear surface unit. Never cover the opening with
foil or any other material. This would
aluminum
prevent the oven vent from working properly.
Unit
(on some models)
Do not lift the surface unit more than one inch. If
you do, it may not lie flat on the drip pan when you
plug it back in.
Repeated lifting of the surface unit more than one
inch above the drip pan can permanently damage
the receptacle.
To replace a surface unit:
Replace the drip pan into the recess in the cooktop.
Make sure opening in the pan lines up with
the receptacle.
Insert the terminals of the surface unit through the
opening in the drip pan and into the receptacle.
Guide the surface unit into place so it rests evenly.
Do not cover the drip pans with aluminum foil. Using
aluminum foil so close to the receptacle could cause
shock, fire or damage to the range.
To replace:
near
Place fingers on the top
each end of the lamp.
Press the lamp into the slots
until it snaps into place.
Move lamp cover down and
snap into place.
Vent
(continued next page)
23