GE Coli Top Owner's Manual page 55

Problem Possible Causes
On Some Models
Display goes blank
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is in the
black-out mode.
Display flashes
Power failure.
Unable to get the
Oven control pads were not
display to show "SF"
touched properly.
"Probe" appears in
This is reminding you to
the display
enter a probe temperature
after plugging in the probe.
Power outage, Power outage or surge.
clock flashes
Steam from the vent
When using the convection
feature, it is normal to see
steam coming out of the oven
vent. As the number of shelves
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily"
This is normal in a new oven
odor emitting from
and will disappear in time.
the vent
Strong odor
An odor from the insulation
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise
A cooling fan or a convection
fan (depending on the
function you are using) may
automatically turn on and off
to cool internal parts.
Surface light does not
Switch operating light is
work
broken.
Warming drawer will
A fuse in your home may be
not work
blown or the circuit breaker
tripped.
Controls improperly set.
Excessive condensation Liquid in drawer.
in the drawer
Uncovered foods.
Temperature setting too high.
Food dries out in the Moisture escaping.
warming drawer
Drawer not fully closed.
What To Do
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at the same time
and held for 3 seconds.
• Enter a probe temperature.
• Reset the clock. If the oven was in use, you must reset it by
touching the CLEAR/OFF pad, setting the clock and resetting
any cooking function.
• This is normal.
• To speed the process, set a self-clean cycle for a minimum of
3 hours. See the Using the self-cleaning oven section.
• This is temporary.
• This is normal. The cooling fan will turn off and on. The convection
fan will run until the function is over or the door is opened.
• Call for service.
• Replace the fuse or reset the circuit breaker.
• See the Warming drawer section.
• Remove liquid.
• Cover food with lid or aluminum foil.
• Reduce temperature setting.
• Cover food with lid or aluminum foil.
• Push drawer in until latch engages.
55