Levehng - GE 164 D2966P073 Use And Care Manual

2.
Aluminum lViring
Connect length of copper building wire to
A.
special connectors designed and UT.L. approved
for joining copper to aluminum, and follow the
connector manufac~urer's recommended
procedure closely.
splices, etc., must conform to good wiring
practice and local codes.
STEP 5
SPECIAL GROUNDING INSTRUCTIONS
WARNING:
through a link. If usecl in a MOBILE HOME or
if LOCAL CODE3S do not permit grounding
through the neutral:
1) disconnect the link from neutral,
unit in accordance with local codes, and
circuit in usual manner.
means of a set, use 4-conductol: cord
for this p
CO NNECT"O
STEP b
for installation in a ~~ariety of locations. The
instructions include a template, a parts list and a
Read the IMPORTANT SAFETY INSTIKJCTIONS
-
0
1
LUG
WARNING
Range must be secured by ANTI-TIP bracket
1.
supplied.
2. See instructions to install (supplied with
bracket).
3. Unless properly installed, range could be
tipped by stepping or sitting on door. Injury
might result from spilled hot liquids or from
range itself.
Typical installation of Anti-Tip bracket
Attachment to Wall
Bracket
STEP 7
LEVELING THE RANGE
The range must be level. Leveling feet are located
at each corner of the base of the range. Remove
the storage drawer or kick panel (depending on
your model) and using channel locks, rotate the
range. (For instructions on how to remove and
replace the storage drawer or the kick panel, see
the Cleaning [Jnder the Range section in Care
and Cleaning.) On some models, there are plastic
covers which may be removed for easy
adjustment (just squeeze and pull).
One of the rear leveling feet will engage the
ANTI-TIP bracket (allow for some side to side
adjustment). Allow a minimum clearance of l/8-
inch between the range and the leveling foot that
is to be installed into the ANTI-TIP bracket.
Check the range for proper installation into the
ANTI-TIP bracket (after the range has been
properly installed) by removing the kick panel or
storage drawer and inspecting the rear leveling
STEP 8
FINAL CHECK
Be sure all switches are in the OFF position
before leaving the range.
35