Anti-Tip Device; Oven Light - GE 164 D2966P073 Use And Care Manual

Proper care and cleaning are important so your range will give you efficient
Follow these
and satisfactory service.
help assure safe and proper maintenance.
BE SURE ELECTRIC POWER IS OFF BEFORE CLEANING ANY PART
OF THE RANGE.
If your range is removed for cleaning, servicing or any reason,
A
be sure anti-tip device is re-engaged properly when the range
is replaced. Failure to take this precaution could result in tipping of
the range and cause injury.
Oven Light Replacement
CAUTION: Before replacing your oven light bulb,
disconnect the electrical power to the range at the
main fuse or circuit breaker panel. Be sure to let
the light cover and bulb cool completely.
The t~ven light bLllb is covered with a removable glass
cover that is held in place with a bail-shaped wire.
To remove:
1. Hold a hand under the
cover so it doesn't fall when
released. With fingers of' the
same hand, firmly push back
the co~er.
2. Do not touch hot bulb with a wet cloth. Replace
bulb with a 40-watt household appliance bulb.
directions carefully in caring for it to
(on some models)
-/ ' ( 3 ',
-_
.
Wire cover holder
To replace cover:
1. Place it into groove of the light receptacle. Pull
wire forward to the center of the cover until it ~naps
into place. When in place. the wire holds the co~er
firmly. Be certain the wire is in the depression in
the center of the cover.
2. Connect electrical power to the range.