GE Profile 165D4700P176 Owner's Manual page 9

Options
2
The light above the pad will be ON to indicate which OPTION has been selected.
HI TEMP RINSE Turns on the heater in all prerinse and final rinse cycles to help prevent spotting on
HI TEMP WASH Energizes the heater in all prewash fill cycles. Recommended for use with heavily
HEATED DRY Shuts off the drying heat options. Dishes air dry naturally and energy is saved. You
OFF can prop the door open after the light goes ON below the word CLEAN.
HEATED DRY Turns the heater on for fast drying. This cycle will extend the time to your wash
ON cycle by 30 minutes. NOTE: Cannot be selected with RINSE & HOLD cycle.
LOCK When the LOCK pad is touched twice within 3 seconds, all pads become inoperative.
DELAY START You can delay the start of a wash cycle for up to 8 hours. Press and hold the
RESET To change a cycle after washing starts, touch the START/RESET pad to cancel
Start
3
Close the door until it locks into place and touch the START/RESET pad to
begin the cycle. There is a time delay between start-up and water fill so you
will not hear any wash action right away.
The cycle is complete when the light is
NOTE: The dishwasher remembers your last cycle so you don't have to
reprogram each time. When the dishwasher is loaded and door latch is in the
locked position, the control panel lights will be
you selected.
If you don't want to change any of the settings, simply touch the START/RESET
pad to begin the cycle.
Also, if a power failure occurs, NORMAL and HEATED DRY
programmed. Make any new selections and touch the START/RESET pad to begin
the cycle.
dishware. This option may be turned ON or OFF during the wash cycle.
soiled dishes. Option may be turned ON or OFF during the wash cycle.
You can lock the controls to prevent any selections from being made. Or you can lock
the controls after you have started a cycle or selected DELAY START so the cycle or
DELAY START is not interrupted.
Children cannot accidentally start dishwasher by touching pads with this
option selected.
To unlock the dishwasher after it has been locked, touch the LOCK pad twice
within three seconds. The light above the LOCK pad will be off.
DELAY START pad to choose the number of hours you want to delay the start
of the cycle. The machine will count down and start automatically at the correct
time. NOTE: If you forget to lock the door a reminder signal will beep until you
do so.
the cycle. After water is pumped out and motor stops, you can reprogram and
restart the dishwasher.
below the word CLEAN.
ON
and display the last settings
ON
will automatically be
ON
9