GE JB940 Owner's Manual page 34

Before YouCall For Service...
Troubleshoot'rig tips
Possible Causes What To Do
You forgot to enter a * Touch the BA/(E pad and desired temperature or
_ _ !i_ _ki J!5_'_ _ bake temperature or the SELF CLEAN pad and desired clean time.
cleaning time.
i;iii!iiii!iiii_iiiii!!i_i!_ii!!iiii_iiii_!i_iii_iiiii_!_!_iiii_
D
A fuse in your home maybe * Replace the fuse or reset the circuit breaker.
+ blown or the circuit
breaker tripped,
The dock is in the • See the Special features of your oven controlsection.
black-out mode.
+
Power failure. • Reset the clock.
Oven control pads were • The BAKE and BR0//H/]_0 pads must be touched at
not touched properly, the same time and held for 3 seconds.
This is reminding you to • Enter a probe temperature.
enter a probe temperature
after plugging in the probe.
Power outage or surge. * Reset the clock. If the oven was in use, you must reset
it by touching the CLF-4R/OFFpad, setting the clock
and resetting any cooking function.
When using the convection * This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of shelves
or amount of food being
cooked increases, the mount
of visible steam will increase.
This is normal in a new oven • To speed the process, set a self-clean cycle for a
and will disappear in time. minimum of 3 hours. See the Using the self-
cleaning oven section.
An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
.... ........... the oven is used.
A cooling fan or a convection • This is normal. The cooling fan will turn off and on.
fan (depending on the The convection fan will run until the function is
function you are using) may over or the door is opened.
automatic turn on and off
to cool internal parts.
Switch operating light • Call for service.
is broken.
34