GE JB940 Owner's Manual page 33

Possible Causes What ToDo
Plug on range ls not completely • Make sure electaical plug is plugged into a live, properly
inset ted in the dectrical outlet, grounded outlet.
A fuse in your home • Replace the fuse or reset the circuit breaker.
may be blown or the
ck'euit breaker tripped.
Oven controls improperly set. * See the Using the clock and timersection.
__lP_eaa The oven temperature is • Allow the range to cool to room temperature and
too high to set a self.dean reset the controls.
operation.
Oven controls
improperly set. • See the
Using the self-cleaning oven section.
The probe is plugged into • Remove the probe from the oven.
!i_!_!iiiiiii_i!i!!i_iiii_iiiiii_i_i!i_i i
the outlet in the oven.
(on some medels)
This is the sound of the • This is normal.
metal heating and cooling
.............................. during both the cooking and
........ cleaning functions.
?:t??? it* ? t?
Excegsive soil.
• Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED D OOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven too hot. • Allow the oven to cool below locking temperature.
oven conU-olsnot properly set. * Seethe Using theself-cleaning o vensecfion.
oven was heavily soiled. • Clean up heavy spillovers before starting the clean
;;iii_ _ i;i;i _i_iS*_i!_!i:iii_i!iii:;:i ii i!
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
The self-clean cycle has been ° Close the oven door.
selected but the door is not
....... closed.
The oven door is locked • Touch the CLEaR/OH: pad. Allow the oven to cool.
because the temperature
inside the oven has not
dropped below the
king loc temperature.
You have a function error code. • Touch the/_AR/OFF pad. Put the oven backinto
operation.
_ :: : If the function code repeats. • Disconnect all power to the range for at least 30
.......... seconds and then reconnect power. If the function
en-or code repeats, call for service.
33