Clock And Timer - GE XL44 Series Use And Care & Installation Manual

Standard-clean models: jgbs03; jgbs04; jgss05; jgbs07; jgbs15; jgbs17; jgbs20; jgbs21; jgbs22; jgbs23 continuous-clean models: jgbc17; jgbc20;
Table of Contents

Advertisement

CLOCK
AND TIMER
(on some models)
Follow the directions
below if your range
has the
clock and timer shown
at the right.
You have the choice of having the timer show the
time counting
down or the time of day. In either case,
the timer will signal at the end of the timer period to
alert you that the time is up.
TMER
,,-- , __,,, SETT
(Appearance
may vary)
To Set the Clock
NOTE: When you first plug in the range or after a
power thilure, the entke Clock!Timer display will light up.
1. Press the CLOCK pad.
2. Press and hold the + or - pad and the time of day
will change 10 minutes at a time. To change the
time by single minutes, give the pads short taps.
3. Press the CLOCK pad to start the clock.
To Set the Timer
1. Press the TIMER ON/OFF pad.
2. Use the + and - pads to set the timer. Short taps on
the + or - pad change the timer's
setting one minute
at a time. Pressing
and continuing
to hold the + pad
increases
the setting ten minutes at a time.
3. Once you have set your timer, press the TIMER
ON/OFF
pad to start timing.
As the timer counts down, a signal will indicate
when one minute is left. After this signal, the display
will count down in seconds. When time _qans out, a
final signal will sound. Press the TIMER ON/OFF
pad to stop the signal.
To Change
or Cancel
the Timer
Setting
When the timer is counting
down, use the + and - pad
to change the remaining
time, or press the TIMER
ON/OFF
pad to stop the timer. The timer cannot be
cancelled
unless you have fully completed
"set timer"
instructions
above.
Display Clock While Timer Is Operating
Pressing
the CLOCK
pad while the timer is operating
will not interfere
with the timer's
operation;
the
display will change to show the clock, but the timer
will continue to count down and will still signal when
time is up. Press the TIMER ON/OFF pad again to
change the display back to show the timer.
Clock
Follow these directions
if
your range has the clock and
timer shown at the right.
To set the clock, push in the
knob and turn it to the right.
Let the knob out when the
clock hands reach the correct
time. Continue
turning the
knob to OFF.
(Appearance
may vary)
Timer
The timer has been combined
with the range clock.
Use it to time all your precise
cooking operations.
You'll recognize
the timer as the pointer that is
different in color than the clock hands.
Minutes
are marked up to 30, and hours are marked
up to 4 on the center of the clock.
To set the timer, turn the knob to the left--without
pushing in--until
the pointer reaches the number of
minutes or hours you want to time.
At the end of the set time, a buzzer sounds to tell
you time is up. Turn the knob--without
pushing
in--until
the pointer reaches OFF and the buzzer stops.
11

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents