GE EER3000 Owner's Manual page 32

Before YouCall ForService...
Troubleshooting -tips
Possible Causes What To Do
"F-- and a number
or letter"flash
in thedisplay
You have a function
error code.
• Press the CLEAR/OFFI)ad. Put the oven back into
operation.
If the fmaction code repeats. • Disconnect all power to the range for at least 30
seconds and then reconnect power. If the flmction
error code repeats, call fin" service.
• On sellXcleaning models, if a fllnction error code
appears during the selt:cleaning cycle, check the oven
door latch. The latch may have been moved, if only
slightly, fl'om the locked position. Make sure the latch
is moved to the right as tar as it will go. Press the
CLEAR/OFFpad.
_Mlow the oxen to cool fin" one houi:
Put the oven back into operation.
Display goes blank A fuse ha your home may be • Rel)lace the fi/se or reset the circuit breaker.
blown or the circuit
breaker tripped.
The clock is turned off • See the
Using the clock and timer
section.
from showing in the display.
Display flashes
Power failure, • Reset the clock.
Unable to get the
Oven control pads were • The BAKE aud
BROILHI/LO pads
must be pressed
displayto show "SF"
not pressed properly, at the same time
and
held for 3 seconds.
Power outage,
Power outage or surge. • Reset the clock./f the oveu was ill use, you must reset
clock flashes
it by 9ressing the
CLEAR/OFF l)ad, _
, l , settin,_ the clock
and resetting any cooking flmction.
"Burning" or "oily"
This is normal ha a new • To sl)eed the process,
set a self:clean
cycle
fi)r a
odor emitting from
oven and will disappear minimum of 3 hours. See the
Using the self-
the vent in time, cleaning oven section.
Strong odor
An odor from the insulation • This is temporaD'.
around the inside of the
oven isnormal f orthefirst
few times the oven is used.
32