GE P2S920SEFSS Dimensions And Installation Information

P2S920SEF
GE Profile Series 30" Dual Fuel Slide-In Range with Warming Drawer
™
Dimensions and Installation Information (in inches)
Note: Door handle protrudes 3" from door face. Cabinets and
3 1/4"
drawers on adjacent 45° and 90° walls should be placed to
avoid interference with the handle.
Note: Cabinets installed adjacent to slide-in ranges must
have an adhesion spec of at least 194° temperature rating.
Installation Information: Before installing, consult
installation instructions packed with product for
current dimensional data.
3 1/4"
18"
26 7/8"
w/o handle
29 3/8"
w/ handle
47 5/8"
Minimum to
cabinets on
either side
SINGLE OVEN SLIDE-IN GAS RANGE
31 1/4"
cooktop edge to edge
SINGLE OVEN SLIDE-IN GAS RANGE
31 1/4"
26 7/8"
w/o handle
cooktop edge to edge
29 3/8"
w/ handle
30"
47 5/8"
Minimum to
cabinets on
either side
30"
of the range.
30"
6" 6"
Minimum
Minimum
Minimum
clearance to
clearance
right wall
to left wall
To cabinets
below 0"
36"
cooktop and
at the range
back
30"
For answers to your Monogram
appliance questions, visit our website at
geappliances.com or call GE Answer Center
service, 800.626.2000.
NOTE: Make gas connections on
the left side and electrical conections
on the right side of the
cutout opening.
3 1/4"
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
This area allows
flush installation
to rear wall.
26 7/8"
w/o handle
29 3/8"
w/ handle
47 5/8"
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
Maximum
depth for
cabinets above
countertops
Minimum to
cabinets on
13"
either side
of the range.
30"
6"
Minimum
Front edge of
Minimum
18"
the range side
clearance
panel forward
to left wall
from cabinet
0"
To cabinets below cooktop
To cabinets
and at the range back
below 0"
cooktop and
at the range
back
*
® or GE ®
®
Maximum
depth for
cabinets above
GAS PIPE AND ELECTRICAL
SINGLE OVEN SLIDE-IN GAS RA
OUTLET LOCATIONS
31 1/4"
30"
cooktop edge to edge
3"
4"
3"
8"
3"
9"
2-1/4 "
NOTE: Make gas connections on
the left side and electrical conections
7-1/2" 2"
on the right side of the
30"
cutout opening.
Maximum
depth for
30"
cabinets above
countertops
Recommended area
6"
Minimum
for through-the-wall
clearance to
right wall
connection of pipe
stub/shut-off valve.
This area allows
36"
flush installation
to rear wall.
7-1/2"
* ADA qualified based
All GE ranges are equipped with
on Uniform Federal an Anti-Tip device. The installation
Accessibility Standards of this device is an important,
required step in the installation
of the range.
Recommended area for
through-the-floor connection
of pipe stub/shut-off valve.
Specification Revised 8/13
Recommended acceptable
electrical outlet area. Orient
the electrical receptacle so the
NOTE: Make gas connections
length is parallel to the floor.
the left side and electrical con
on the right side of the
cutout opening.
Wall-Mounted
GAS PIPE AND ELECTR
35" to 36 1/2"
OUTLET LOCATION
floor to counter
Recommended area
for through-the-wall
connection of pipe
stub/shut-off valve.
This area allows
flush installation
30"
to rear wall.
Product is shipped with 4-prong
plug. Recommended outlet is
7-1/2"
a NEMA 14-50R receptacle.
3"
Recommended area for
4"
through-the-floor connection
3"
8"
of pipe stub/shut-off valve.
3"
9"
13"
Front edge of
the range side
panel forward
from cabinet
0"
2-1/4 "
To cabinets below cooktop
and at the range back
2"
Listed by
Underwriters
Laboratories
Produc
plug. R
a NEM
221226
3"
9
Reco
elect
the e
lengt
Wal