GE JGBP29 Owner's Manual And Installation Instructions page 27

GEAppliances.com
ii_iI ,i ii
Grate
<7/ "
Drip pan (if so equipped)
Surface burner
tI, CAUTION:
Do not operate the cooktop without all
burner parts, drip pans (if so equipped)
and grates in place.
Standard Twin Burner Assemblies (on some models)
For cleaning information on sealed burners,
see section below. Sealed burner cooktops
do not lift up.
On models with standard twin burners, the
cooktop lifts up for easy access.
Turn all controls OFFbefore removing burner
parts and drip pans (if so equipped).
The burner grates and drip pans (if so equipped)
can be lifted off, making them easy to clean.
The holes in the surface burners of your range
must be kept clean at all times for proper
ignition and an even, unhampered flame.
You should clean the surface burners routinely,
especially after bad spillovers,which could clog
these holes.
For more stubborn stains, use a cleanser like
Soft Scrub®brand or Ban Ami®brand. Rinsewell
to remove any traces of the cleanser that might
clog the surface burner openings.
Do not use steel wool because it will clog the
surface burner openings and scratch the
surface burners. If the holes become clogged,
clean them with a sewing needle or twist-tie.
Before putting the surface burner back, shake
out excess water and then dry it thoroughly by
setting it in a warm oven for 30 minutes. Then
place it back in the range, making sure it is
properly seated and level.
Checkthe flame pattern of each burner. If the
flames are 'jumpy" (not steady), clean the holes
again with a sewing needle or twist-tie.
Wipe off surface burners. If heavy spillover
occurs, remove the surface burners from the
range. Burners lift out for cleaning. Lift up the
cooktop and then lift out the surface burners.
To remove burned-on food, soak the surface
burner in a solution of mild liquid detergent and
hot water. Soak the surface burner for 20 to :30
minutes.
Clean these holes thoroughly on each
burner.
Grate
Burner cad
0
Burner neaa
_/Drip pan(if_,_
Electrode r-_u+_
Sealed Burner Assemblies (onsomemodels)
Turn all controls OFFbefore removing the
burner parts and drip pans (if so equipped).
The burner grates, caps, burner heads and drip
pans (ifso equipped) can be lifted off, making
them easy to clean.
CAUTION: oo
not operate
the
cooktop without all burner parts, drip pans (ifso
equipped) and grates in place.
NOTE:Do not lift the cooktop. Lifting the cooktop
on sealed burner models con lead to damage
and improper operation of the range.
The electrode of the spark igniter is
exposed when the burner head is
removed. When one burner isturned
to LITE, all the burners spark. Do not
attempt to disassemble or clean around
any burner while another burner ison.
An electric shock may result,which could
cause you to knock over hot cookware.
27