GE JGBP29 Owner's Manual And Installation Instructions page 166

Using the ovencontrols.
Throughout this manual, features and appearance may vary from your model.
O_ven Contro_ls
roo' e
Temp Recatl
°
T:. contr's
e / ¸
f-Kitchen_ €Clock- _
Tim rJ 'j
On / Off
¢Oven-_ _ °°king_{rSt:rt-_
_._Time _._Time )
L'--Lighftf _ n_ /,.j_utomati: _en
10
Oven Control, Clock and Timer Features and Settings ron s ome mode s
Bake/Temp Recoil Pad @
Touch this pad to select the bake function.
Bake Light
Flasheswhile in edit mode-you can change the
oven temperature at this point. Glowswhen the
oven is in bake mode.
Start/On Pad
Must be touched to start any cooking or cleaning
function.
O isplay
Shows the time of day, oven temperature,
whether the oven is in the bake, broil or self-
cleaning mode and the times set for the timer or
automatic oven operations. The display will show
PREwhile preheating. When the oven reaches the
selected temperature, the oven control will beep
and the display will show the oven temperature.
If "F-" and a number or letter flash in the display and the
oven control signals,this indicates a function error code.
If your oven was set for a timed oven operation and a
power outage occurred, the clock and all proogrommed
functions must be reset.
0
0
Kitchen Timer On/Off Pad
Touch this pad to select the timer feature.
Then press the + and - pads to adjust the timer.
Timer Light
Flasheswhile in edit mode-you can change
the set time at this point. Glowswhen the timer has
been activated. Flashesagain when the time has
run out until the control is reset.
Clock Pad
To set the clock, press this pad twice and then
press the + and - pads. The time of day will flash
in the display when the oven is first
turned on.
Start Time Pad (on some models)
Use along with the Cooking Time or Self
Clean pads to set the oven to start and stop
automatically at a time you set.
Start Time Light
Flasheswhile in edit mode-you can change
the start time at this point. Glowswhen the function
has been activated.
Thetime of day will flash in the display when there has
been a power outage. Resetthe clock.
If the function error code appears during the self-cleaning
cycle,check the oven door latch. Thelatch handle may
have been moved, even if only slightly, from the latched
position. Make sure the latch is moved to the right as far
as it will go.
Touch the Clear/Off pad. Allow the oven to cool for one
hour. Put the oven back into operation. If the function
error code repeats, disconnect the power to the range
and call for service.
0
Cooking Time Pad (on some models)
Touch this pad and then touch the + or - pads
to set the amount of time you want your food
to cook. The oven will shut off when the cooking
time has run out.
Cooking Time Light
Flasheswhile in edit mode-you can change
the set time at this point. Glowswhen the function
has been activated.Flashesagain when the time
has run out until the control is reset.