Leveling The Range - GE JGBP29 Owner's Manual And Installation Instructions

Installation Instructions
[] CHECK OPERATION OF OVEN BURNERS
(CONT.)
B.Tooperatethe Bukeburner,pressthe Bukepod und then
pressthe numberpods until350 uppeurs in the display. Press
the Sturt/Onpod. After 30 to 90 seconds, t he burnerwill ignite.
Flumesshouldbe steady,approximately1" bluecones and,if
runge is suppliedwith natural gas,shouldburn with no yellow
tips. With most LPgas, smullyellow tips ut the end of outer gas
conesore normul. Theinner coneof the flume shouldbe 1A" to
3A"long for either gas.
Inner cone
of flame
Oven broiler burner
C.Performthe some checkon the broil burner by touching the
BroilHi/Lopod and then the Start/Onpod.
[] ADJUST THE BAKE AND BROIL
BURNER AIR SHUTTERS IF NECESSARY
(CONT.)
The air shutter for the broil burner is accessible in the top
rear of the oven.
B. Using o screwdriver, loosen the air shutter adjustment
screw.
C. Make the air shutter adjustment.
D. Retighten the air shutter screw.
E. Check that the inner cone of the flume is between 1A"
and sA"(12.7mm and 19.1 mm)long.
After confirming correct burner operation,
replace all parts
ADJUST THE BAKE AND BROIL
BURNER AIR SHUTTERS IF NECESSARY
What adjustment to make:
A. If the flumes ore yellow, open the air shutter more than
the original setting.
B.If the flumes blow owoy or flutter from the burner, close
the air shutter more than the original setting.
Making the adjustment
A. Locate the Air Shutter
The air shutter for the bake burner is near the
buck wall behind the storage drawer, worming
drawer or kick panel. Removethe drawer or
panel. Seethe Core and cleaning of the range
section.
\
ustment
shutter
I
[] LEVELING THE RANGE
A. Install the oven rocks in the oven and position
the range where it will be installed.
Raise
range
Leg _ A
levele r"'"_ _
Raise J
range_
Lower
range
Ion some models) Ion some models)
B. Checkfor levelnessby placing o spirit level or o cup,
partially filled with water, on one of the oven rocks.
If using o spirit level,take two readings-with the level
placed diagonally first in one direction and then
the other.
C.
D.
Removethe storage drawer or kick panel. See the Core
and cleaning of the range section. The front leveling legs
con be adjusted from the bottom and the rear legs con
be adjusted from the top or the bottom.
Use on open-end or adjustable wrench to adjust
the leveling legs until the range is level.
After the range is level,slide the range owoy from
the wall so that the Anti-Tip device con be installed.
43