GE JM250DFCC Dimensions And Installation Information

JM250DF
GE 27" Drop-In Electric Range
Dimensions and Installation Information (in inches)
Note: This appliance has been approved for 0" spacing to adjacent surfaces
above the cooktop. However, a 6" minimum spacing to surfaces less than 15"
above the cooktop and adjacent cabinet is recommended to reduce exposure
to steam, grease splatter and heat.
Optional Backguard
(Available at additional cost)
JX27RBK (Black)
JX27RWH (White)
Installation Information: Before installing, consult installation instruc-
tions for current dimensional data and additional requirements.
KW Rating
240V 10.6
208V 8.0
13/32
Breaker Size
240V 40 Amp
†
208V
40 Amp †
NOTE: Check local codes
†
for required breaker size
*If countertop edge is formed, this
dimension must extend to flat area
In replacement installation, use
JX27R optional backguard, if required
Countertop cutout
top view
Inside back wall of cabinet
or rear wall
1-1/2" MIN.
Clearance
3/8" MIN. Flat
23-3/8" MIN.*
22-7/8"
21-3/4" cabinet Flat
Cutout
counter
face to rear
of cutout
26-1/4" MAX.
Smooth cut
For answers to your Monogram
appliance questions, visit our website at
geappliances.com or call GE Answer Center
service, 800.626.2000.
27" Drop-In Ranges
Dimensions (in inches)
Important: This range is designed to hang from the
countertop. It does not rest on the floor.
Countertop
If necessary, build up
sides to 1-1/2" thick to
provide screw
anchor surface and
countertop support
These screws are
anti-tip devices
and must be installed
in the front and rear
24-3/16
22-3/16
2
20
Door
clearance
ADA qualified based
*
on Uniform Federal
Accessibility Standards
® or GE ®
®
Trim section for
countertop with
post formed
or raised
Range side
front edge
support
30" MIN. to
bottom of
cabinet
over
range
18
27-1/8
28-1/2"
MIN.
28-7/16
27" Between
cabinets
anywhere in shaded area
22-3/16
Back of range Conduit is 48-1/2" long
to front of
closed door
All GE ranges are equipped with
an Anti-Tip device. The installation
of this device is an important,
required step in the installation
of the range.
Specification Created 6/13
13/32
*If counte
dimensio
In replace
JX27R op
Locate junction box
Listed by
Underwriters
Laboratories
320908