HP G62-400 - Notebook PC Maintenance And Service Manual page 55

3. Remove the three Phillips PM2.5×5.0 screws 1 that secure the hard drive to the computer.
4. Grasp the Mylar tabs 2 on the hard drive, and then slide the hard drive to the left to disconnect it from
the system board.
5. Disconnect the hard drive cable from the system board 3.
6. Remove the hard drive 4 from the hard drive bay.
7. To replace the hard drive bracket, remove the four Phillips PM3.0×4.0 hard drive bracket screws 1 from each
side of the hard drive.
8. Grasp the 2 attached Mylar tabs 2 and pull the bracket straight up to remove it from the hard drive.
Reverse this procedure to reassemble and install the hard drive.
Maintenance and Service Guide
Removal and replacement procedures
4–9