Table of Contents
Advertisement
USB connector module
Description
Cable Kit
Before removing the USB connector module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Switch cover and keyboard (see
b.
Memory module (see
c.
Optical drive (see
d.
Speakers (see
e.
Palm rest (see
f.
WLAN module (see
g.
Hard drive (see
h.
Display assembly (see
i.
Top Cover (see
Remove the USB connector module:
1.
Disconnect the USB cable from the system board (1).
2.
Lift up the USB cable from the routing channels in the base enclosure (2).
3.
Remove the short Phillips PM2.5×3.0 screw (3) and the long Phillips PM2.5×9.0 screw (4) that
secure the USB connector module to the base enclosure.
Battery on page
42).
Switch cover and keyboard on page
Memory module on page
Optical drive on page
Speakers on page
50)
Palm rest on page
51)
WLAN module on page
Hard drive on page
53)
Display assembly on page
Top cover on page
66)
Spare part number
535757-001
46)
48)
56)
60)
Component replacement procedures
43)
71
Advertisement
Table of Contents
