Table of Contents
Advertisement
Reverse this procedure to install the power button board.
Modem module
Description
For use in all countries and regions except Australia and New Zealand
For use only in Australia and New Zealand
Before removing the modem module, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Switch cover and keyboard (see
b.
Memory module (see
c.
Optical drive (see
d.
Speakers (see
e.
Palm rest (see
f.
WLAN module (see
g.
Hard drive (see
h.
Display assembly (see
i.
Top cover (see
Remove the modem module:
1.
Remove the two Phillips PM2.5×3.0 screws (1) that secure the modem module to the system
board.
2.
Lift the rear edge of the modem module (2) to release it from the system board.
Battery on page
42).
Switch cover and keyboard on page
Memory module on page
Optical drive on page
Speakers on page
50)
Palm rest on page
51)
WLAN module on page
Hard drive on page
53)
Display assembly on page
Top cover on page
66)
46)
48)
56)
60)
Component replacement procedures
Spare part number
510100-001
510100-011
43)
69
Advertisement
Table of Contents
