HP FM850UT - SMART BUY 4710S T6570 Notebook Maintenance And Service Manual page 72

2. If it is necessary to replace the display bezel or display hinges, remove the eight rubber screw
covers (1) and the eight Phillips PM2.5×4.5 screws (2) that secure the display bezel to the
display assembly. The rubber screw covers are available in the Rubber Kit, spare part number
535793-001.
3. Lift the top inside edge of the display bezel (1) to detach it from the display assembly.
4. Lift the left and right inside edges of the of display bezel (2) to carefully detach them from the
display assembly.
5. Carefully lift the bottom inside edge of the display bezel (3) to detach it from the display
assembly.
NOTE:
6. Carefully remove the upper hinge cover clips from the lower hinge covers on the display
assembly.
CAUTION:
upper hinge cover clips.
7. Remove the display bezel from the display assembly (4). The display bezel is available using
spare part numbers 535770-001 (for use only with models without a webcam) and 535769-001
(for use only with models with a webcam).
62 Chapter 4 Removal and replacement procedures
Make note of the routing of the display cable and the wireless antenna cable.
The lower hinge covers can be damaged if care is not taken when removing the