Table of Contents
Advertisement
Hard drive
NOTE:
All hard drive spare part kits include a hard drive bracket.
Description
500-GB, 7200-rpm hard drive
320-GB, 7200-rpm hard drive
320-GB, 5400-rpm hard drive
250-GB, 7200-rpm hard drive
250-GB, 5400-rpm hard drive
160-GB, 7200-rpm hard drive
Hard Drive Hardware Kit
Before removing the hard drive, follow these steps:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the switch cover and keyboard (see
6.
Remove the palm rest (see
Remove the hard drive:
1.
Position the computer with the front toward you.
2.
Loosen the two Phillips PM2.0×4.0 screws (1) that secure the hard drive to the computer.
3.
Loosen the Phillips PM2.5×10.0 captive screw (2) that secures the hard drive to the computer.
4.
Grasp the Mylar tab (3) on the hard drive and slide the hard drive to the right to disconnect it
from the system board.
Battery on page
42).
Switch cover and keyboard on page
Palm rest on page
51).
Spare part number
634920-001
603783-001
622643-001
538972-001
535763-001
577972-001
630891-001
Component replacement procedures
43).
53
Advertisement
Table of Contents
