Optical Drive Connector Cable - HP ENVY dv7-7200 Maintenance And Service Manual

3. Remove the subwoofer (2).
NOTE:
the performance of the subwoofer.
Reverse this procedure to install the subwoofer.

Optical drive connector cable

NOTE: The optical drive connector cable is included in the optical drive spare part kit. See
Optical drive on page 53
Before removing the optical drive connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
e. System board (see
f. Subwoofer (see
90 Chapter 4 Removal and replacement procedures
The subwoofer includes four rubber isolators (3). These isolators are crucial to
for optical drive spare part number information.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Top cover on page
System board on page
Subwoofer on page
47), and then remove the following components:
48)
53)
59)
63)
77)
89)