Fan/Heat Sink Assembly - HP ENVY dv7-7200 Maintenance And Service Manual

12. Lift the right side of the system board (2) until it rests at an angle.
13. Remove the system board (3) by sliding it up and to the right at angle.
Reverse this procedure to install the system board.

Fan/heat sink assembly

NOTE: The fan/heat sink assembly spare part kit includes replacement thermal material.
Description
For use only on computer models equipped with an AMD processor
For use only on computer models equipped with an Intel processor and a graphics subsystem with
discrete memory
For use only on computer models equipped with an Intel processor and a graphics subsystem with
UMA memory
NOTE: To properly ventilate the computer, allow at least 7.6 cm (3 in) of clearance on the left side of
the computer. The computer uses an electric fan for ventilation. The fan is controlled by a temperature
sensor and is designed to turn on automatically when high temperature conditions exist. These
conditions are affected by high external temperatures, system power consumption, power
management/battery conservation configurations, battery fast charging, and software requirements.
Exhaust air is displaced through the ventilation grill located on the left side of the computer.
Before removing the fan/heat sink assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. Optical drive (see
Battery on page 47), and then remove the following components:
Hard drive on page 48)
Optical drive on page 53)
Component replacement procedures
Spare part number
682178-001
682061-001
682060-001
81