Power Connector Cable - HP ENVY dv7-7200 Maintenance And Service Manual

Power connector cable

Description
For use only on computer models equipped with an AMD processor
For use only on computer models equipped with an Intel processor
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Remove the power connector cable:
1. Disconnect the power connector cable (1) from the system board.
2. Release the power connector cable from the clips (2) and routing channel built into
the base enclosure.
3. Release the tape that secures the power connector (3) to the base enclosure.
Battery on page 47), and then remove the following components:
Hard drive on page 48)
Optical drive on page
Keyboard on page 59)
Top cover on page 63)
53)
Component replacement procedures
Spare part number
681973-001
681974-001
75