3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the USB board:
1.
Disconnect the USB board cable (1) from the system board.
2.
Detach the USB board cable (2) from the system board and base enclosure. (The USB
board cable is attached to the system board and the base enclosure with double-sided tape.)
3.
Remove the Phillips PM2.5×4.0 screw (3) that secures the USB board to the base enclosure.
4.
Remove the USB board (4).
Reverse this procedure to install the USB board.
74
Chapter 4 Removal and replacement procedures
Battery on page
47), and then remove the following components:
Hard drive on page
48)
Optical drive on page
Keyboard on page
59)
Top cover on page
63)
53)