c.
Keyboard (see
d.
Top cover (see
Remove the solid-state drive:
1.
Remove the Phillips PM2.0×3.0 screw (1) that secures the solid-state drive to the system board.
(The solid-state drive tilts up.)
2.
Remove the solid-state drive by pulling the drive away from the slot at an angle (2).
NOTE:
the solid-state drive slot.
Reverse this procedure to install the solid-state drive.
USB board
Description
USB board (includes cable)
Before removing the USB board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
Keyboard on page
Top cover on page
The solid-state drive is designed with a notch to prevent incorrect installation into
59)
63)
Component replacement procedures
Spare part number
681986-001
73