8.
Slide the TouchPad button board bracket (3) up and away from the top cover until the tabs (4) on
the front edge of the bracket disengage from the slots (5) on the top cover.
Reverse this procedure to install the TouchPad button board.
Solid-state drive
Description
180-GB solid-state drive for use on all computer models
160-GB solid-state drive for use on all computer models
32-GB mSATA solid-state drive for use only on computer models equipped with an Intel processor
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the battery (see
a.
Hard drive (see
b.
Optical drive (see
72
Chapter 4 Removal and replacement procedures
Battery on page
47), and then remove the following components:
Hard drive on page
48)
Optical drive on page
53)
Spare part number
699330-001
681997-001
682099-001