Power Button Board - HP ENVY dv7-7200 Maintenance And Service Manual

Reverse this procedure to install the front speakers.

Power button board

Description
Power button board (includes cable)
Before removing the power button board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the battery (see
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2. Detach the power button board cable (1) from the top cover. (The power button board cable is
attached to the top cover double-sided tape.)
3. Remove the Phillips PM2.0×4.0 screw (2) that secures the power button board to the top cover.
68 Chapter 4 Removal and replacement procedures
Battery on page 47), and then remove the following components:
Hard drive on page 48)
Optical drive on page
Keyboard on page 59)
Top cover on page 63)
53)
Spare part number
681985-001