HP ENVY dv7-7200 Maintenance And Service Manual page 101

4. Release the wireless antenna cables (4) from the clips (5) built into the base enclosure.
CAUTION: Support the display assembly when removing the following screws. Failure to
support the display assembly can result in damage to the display assembly and other
computer components.
5. Remove the four Phillips PM2.5×8.5 screws (1) that secure the display assembly to
the base enclosure.
6. Remove the display assembly (2).
7. If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a. Remove the display bezel screw cover strip (1) and the two Phillips PM2.5×5.0 screws (2)
that secure the display bezel to the display assembly. The display bezel screw cover strip is
available in the Display Screw Kit, spare part number 681993-001.
b.
Flex the inside edges of the bottom edge (3), the left and right sides (4),
and the top edge (5) of the display bezel until the bezel disengages from
the display enclosure.
Component replacement procedures
93