Dyson DC02 Operating Manual

1
2
IMPORTANT Use only genuine Dyson filters.
Sits securely
on the stairs
However, always
work above the
machine on stairs for
your own safety.
1. Hose & wand
assembly
The plug is situated
underneath the tool
Assemble hose and wand by fitting
cover on the right
together at joints
hand side.
yellow cuffs in until both buttons 'click'
into place.
On/off switch
Press buttons and pull hose to release
Press left switch.
Tool storage
Press yellow release catch to open the tool
storage cover and insert required tool into
end of wand or wand handle. Please
note that tools may feel warm when
machine has been running; this is
perfectly normal.
Cord rewind
Press right switch for cord rewind.
Changing filters
Your DCO2 is fitted with one H-level electrostatic cartridge
filter and one HEPA filter.
Insert top H-level electrostatic filter ensuring that it fits
1
snugly against the black rubber seal on the machine.
Slide purple HEPA filter into the grooves and push it
2
down fully.
2
click
1
, , and . Push
1 2 3
.
Wand
handle
W A R N I N G !
For your own safety please
remember to unplug the machine when not in
use and before carrying out maintenance.
H
H-Level
1 H-level
&
Absolute
1 HEPA
HEPA
Bactiguard
Automatic suction control trigger
Hold the yellow trigger down to reduce suction for
upholstery and curtains.
To maintain reduced suction, press the trigger down
hard until it clicks. To unlock and resume full suction,
press down the opposite end of the trigger.
Telescopic wand
Blockage procedure
Press yellow button and
3
Please note: Any 'Blockage only' repairs will incur a
slide wand down to
charge of $60.00
adjust length.
Check filters, replacing S-level if older than 3 months
and HEPA if older than 12 months, or if filters are heavily
coated with dust.
*Price correct at time
of printing.
1. Check entry swivel
pressing yellow buttons &
pulling out hose.
Clear any debris.
2
3. Check wand joint
by pulling wand
and wand handle
apart. Clear any blockage
Self adjusting
with rod or wire.
Floor tool
Fit floor tool by pushing
4
firmly into end of wand.
Wand
5. Check air intake hole and check ramp.
2. Clear bin removal
To empty clear bin, pull back release catch under carrying handle
1
and raise top of machine.
*
. Please check your machine carefully.
Lift clear bin out of machine.
2
by
1 1
2. Check wand handle swivel
2
by pressing yellow buttons and
pulling hose from wand. Clear
any debris.
4 Wrap a plastic bag
tightly around the rim
of the clear bin.
3
3
4. Remove floor tool from
wand and check for
4 Wipe shroud holes
6
blockage.
free of all dust/debris.
Clear bin full mark
Note: Do not fill above this line.
Remove cyclone top (lid).
3
5 Invert clear bin and wait at least
10 seconds before releasing.
OPTIONAL
Do not use strong
7
detergents and ensure
clear bin is fully dry before
replacing in machine.
Note: The yellow bin inner
should not be removed from
click
the bin when it is cleaned.
Replace clear bin and cyclone
8
top and close machine.
Ensure release catch
'clicks' into position before
using the vacuum cleaner or
lifting the machine by the
carrying handle.