Modem module
Description
All countries and regions except for Australia and New Zealand (for model 1.0 only)
Australia and New Zealand (for model 1.0 only)
Before removing the modem module:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the modem module:
1.
Turn the computer upright with the front toward you.
2.
Remove the two Phillips PM2.0×3.0 screws (1) that secure the modem module to the system
board.
ENWW
Battery on page
46).
Hard drive on page
47)
Optical drive on page
Keyboard on page
57)
Top cover on page
59)
50)
Component replacement procedures
Spare part number
510100-001
510100-011
65