Power button board
Description
Power button board
Before removing the power button board:
1.
Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn on
the computer, and then shut it down through the operating system.
2.
Disconnect all external devices connected to the computer.
3.
Disconnect the power from the computer by first disconnecting the power cord from the AC
outlet and then disconnecting the AC adapter from the computer.
4.
Remove the battery (see
5.
Remove the following components:
a.
Hard drive (see
b.
Optical drive (see
c.
Keyboard (see
d.
Top cover (see
Remove the power button board:
1.
Turn the top cover upside down with the rear edge toward you.
2.
Remove the Phillips PM2.0×3.0 screw (1) that secures the power button board to the top cover.
3.
Lift up and remove the power button board (2).
Reverse this procedure to install the power button board.
ENWW
Battery on page
46).
Hard drive on page
47)
Optical drive on page
Keyboard on page
57)
Top cover on page
59)
50)
Component replacement procedures
Spare part number
595204-001
63