Operating The Self-Cleaning Oven - GE JB552G Use And Care Manual

Care and Cleaning
Operating the
Self-Cleaning Oven
Before Setting Oven Controls,
Cheek These Things:
Step h
Remove broiler pall broiler rack
aim other cookware from the oven.
(Oven shelves may be left in oven.
Note: Shelves may become gray
after several cleanings. )
Step 2:
Remove auy combustible items
from the storage &awer. This
includes utensils with plastic
haudtes that cau become overheated
aud melt. Remove all utensils and
food from the cooktop.
Step 3:
Wipe up heavy soil on oven
bottom.
A. Oven Front Frame
B. Oven Door Gasket
C. Openings in Door
D. Oven Light
Step 4:
Clean spatters or spills on oven
tiom tTame (A) and oven door
outside gasket (B) with a dampened
cloth. Polish with a dry cloth. Do
not cleau gasket (B). Do not allow
water to run down through openings
in top of door (C). Never use a
commercial oven cleaner in or
around self-cleaning oven.
Step 5:
Close oven door aud make sure
oven light (D) is off.
How to Set Oven for Cleaning
Step 1:
Touch the OVEN CLEAN button.
C, 3:00 is displayed to indicate
three hours cleaning time.
Step 2:
Turn OVEN SET knob to CLEAN.
CAUTION: Any time the OVEN
SET kuob is set to clean position
and the door is not latched, a buzzing
sound will remind you to lock the
door promptly. Allowing the buzz to
contilme for au extended time may
cause damage to the lock system so
that the door calmot be latched.
Step 2:
Rotate the door latch to its locked
position. The buzzer will stop and
cleaning will begin.
\
\.
• Use of surface elements while
the rauge is self-cleaning is not
recommended.
* When the COOK POT is displayed
after about half
an hour,
the oven is
at cleaning temperature aim the
oven door is locked.
22
• When cleauing is complete aud
the oven has cooled below cleaning
temperature, the COOK POT
display goes out aud the door may
be unlatched. Display returns to
time of day.
* To stop au oven cleaning cycle
after cleauing has begun: Press
the OVEN CLEAN button twice
within, one second to caucel. When
COOK POT display goes out, door
can be unlocked.
• To display time of day after
setting self clean cycle: Press aud
hold CLOCK/SIGNAL OFF button.
How to Delay Start and Stop
of Self Cleaning
Step h
Make sure the rauge clock shows
the correct time of day.
Step 2:
Oven is preset to eleau for 3 hours
but you may set cleau for 2-4
hours. Less than 2 hours is not
recommended.
To chauge cleaning time, touch
OVEN CLEAN button and turn
ADJ. OVEN TIME-TEMP. knob to
your desired cleaning time.
Note: Preset cleaning cycle will
begin 4 seconds after touching
OVEN CLEAN button. If you still
waut to chauge cleaning time,
touch OVEN CLEAN button twice
to cancel and begin again.
Step 3:
Touch STOP TIME button aud turn
ADJ. TIME-TEMP. knob to the
time you waut the self-cleau cycle
to end. Be sure the stop time is 3 or
more hours later than the present
time of day.