Table of Contents
Advertisement
Available languages
Available languages
GEAppliances.com
Possible
Causes
What
To Do
LOC shows in the
The Gas/Control Lockout feature
. Be sure the surface burner controls are turned OFF.
display
is activated.
Turn this feature off to use the range. See the Gas/Control
Lockout section.
Display_
A fuse in your home may be
• Replace the fuse or reset the circuit breaker.
blown or the circuit breaker
tripped.
The clock is in the
. See the Special features ofyour oven control section.
blackout mode.
Display flashes
Power failure.
. Reset the clock.
Unable to get the
Oven control pads were
. The Bake and Broil Hi/Lo pads must be touched at
display to show "SF"
not pressed
properly,
the same time and held for 3 seconds.
Power outage,
Power outage
or surge.
. Reset the clock. If the oven was in use, you must reset
clock flashes
it by touching the Clear/Off pad, setting the clock
and resetting any cooking function.
"Burning" or "oily"
This is normal in a new oven
. To speed the process, set a self-clean cycle for a
odor emitting from
and will disappear in time.
minimum of 3 hours. See the Using the self-cleaning
the vent
oven section.
Strong odor
An odor from the insulation
. This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fan noise (some models)
A cooling fan or a convection fan.
This is normal. The cooling fan will turn on to cool internal
Idepending on the function you
parts. It may run up to !-!/2
hrs after the oven is turned
are using} may automatically turn
off. The convection fan will cycle on and off until the
on.
function is over or the door is opened.
Convection
fan not
Preheat temperature
working Isome models)
not reached.
. Fan will start automatically once the preheat
temperature is reached.
52
Advertisement
Table of Contents
