GE Appliances JGB850 Owner's Manual And Installation Instructions page 51

Before you call for service...
Troubleshooting Tips
Excessive smoking
Possible Causes What To Do
Excessive soil.
Oven door will not open
after a clean cycle
Touch the Clear/Off pad or turn the upper oven knob to the.
OFFposition and press the Clear/Off pad. Open the windows
to rid the room of smoke. Wait until the LOCKEDDOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
Oven too hot.
Allow the oven to cool below locking temperature.
Do not lock the door with the door latch except when
using the self-clean feature.
Oven not clean after a Oven controls not properly set. • See the Using the self-cleaning upper and lower ovens section.
clean cycle Oven was heavily soiled. . Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
"Door" appears in the Latch handle was moved to the _ Move the latch handle to the right only when setting
display (on models right but a program other than the self-cleaning cycle.
with a door latch) self-clean was selected.
"LOCKDOOR" flashes
in the display
LOCKED DOOR light
is on when you want
to cook
The self-clean cycle has been
selected but the door is not
closed and on models with a latch,
the latch was not moved all the
way to the right.
The oven door is locked
beca use the tam peratu re
inside the oven has not
dropped below the
locking temperature.
Close the oven door and on models with a latch, move
the latch all the way to the right.
Touch the Clear/Off pad. Allow the oven to cool
and then, on models with a door latch, unlock the door.
"F--" and a number or
letter flash in the display
On models with a door latch,
if a function error code appears
during the self-cleaning cycle,
check the oven door latch.
The latch may have been moved, even if only slightly,
from the locked position. Make sure the latch is moved
to the right as far as it will go.
You have a function error code.
Touch the Clear/Off pad. Allow the oven to cool for
one hour. Put the oven back into operation.
If the function code repeats. Disconnect all power to the range for 5 minutes
and then reconnect power. If the function error
code repeats, call for service.
Oven racks are
difficult to slide
The nickel racks (if so equipped)
were cleaned in a self-clean cycle.
The gray porcelain-coated racks
(if so equipped)were improperly
cleaned.
Apply a small amount of vegetable oil to a paper
towel and wipe the edges of the oven racks with
the paper towel. Do not spray with Pam®or other
lubricant sprays.
"Probe" appears in This is reminding you to enter a _ Entera probe temperature.
the display (somemodels) probe temperature after plugging
in the probe.
51