Racks - GE Appliances JGB500 Owner's Manual And Installation Instructions

Using the upper oven.
OEAppliances.com
To avoid possible bums, _lace the racks in the desired position before you turn the oven on.
Before you begin...
The rocks hove stop-locks, so that when
placed correctlg on the rock supports (A
through E),theg will stop before coming
completelg out, and will not tilt.
When placing and removing cookware,
pull the rock out to the bump on the rock
support.
To remove a rack, pull it toward gou, tilt the
front end up and pull it out.
To replace, place the end of the rock (stop-
locks)on the support, tilt up the front and
push the rock in.
NOTE:The rack is not designed to slide out
at the special low rack (R)position.
The ovenhas 5 rack positions.
It also has a special low rack position
(R)for extralarge items,suchas a large
turkey.
Plasticitems on the cooktopmay melt if
left too closeto the vent.
Vent appearance and location vary.
Upper Oven Vent
Your oven is vented through ducts at the rear
of the range. Do not block these ducts when
cooking in the oven-it is important that the
flow of hot air from the oven and fresh air
to the oven burner be uninterrupted. Avoid
touching the vent openings or nearbg
surfaces during oven or broiler operation-
theg Tag become hot.
, Handles of pots and pans on the cooktop
may become hot if left too close to the vent.
, Do not leaveplastic or flammable items on
the cooktop-they mablmelt or ignite if left
too close to the vent.
Do not leave dosed containers on the
cooktop. The pressure in closed containers
Tag increase, which Tag cause them
to burst.
Metal items will become verg hot if theg are
left on the cooktop, and could cause bums.
Power Outage
CAUTION:Do not make any attempt to
operate the electric ignition oven during an
electrical power failure.
The oven or broiler cannot be lit during a
power failure. Gaswill not flow unless the
glow bar is hot.
If the oven is in use when a power failure
occurs, the oven burner shuts off and cannot
be relit until power is restored.This is because
the flow of gas is automaticallg stopped and
will not resume when power is restored until
the glow bar has reached operating
temperature.
Upper Oven Light
Touch the Oven Light pad on the upper
control panel to turn the light on or off.
On some models, the Oven Light switch
is on the lower front control panel.
13