GE Appliances XL44 JGBP24 Use & Care Manual And Installation Instructions page 41

[] CONVERTING SURFACE BURNERS ON
MODELS EQUIPPEDWITH SEALED BURNERS
(See Step 4 if range is equipped with standard
twin burners.)
Burner Cap
Burner Head
Screws ,!
Burner Base
Orifice Spud
Gas Inlet Tube
1. Remove grates, burner caps and burner heads.
2. Using a torxdriver, remove the burner bases
by unscrewing the 3 small screws in each base.
Lift the burner straight out.
DO NOT disconnect the wires from the burner
bases unless the cooktop needs to be raised.
3. Remove the brass orifice spud under each
burner base by unscrewing spud from fitting with
a 7 mm or a small adjustable wrench (depending
on the size of your spuds). Apply a 3/4" wrench
to the hex on the gas inlet robe as a back-up
when removing spud to prevent the
aluminum from twisting.
4. Install orifice spuds accordh=gto one of the
following diagrams (see II or ____1), for LP
gas or natural gas, depending on which you are
converting to.
[--I Orifice Spudsfor Converting to LP Gas:
LP orifice spuds are in a small plastic bag packed
with this Use and Care Guide. LP orifice spuds
have a 2-digit number and the letter "L" on one
side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on the
range where it is to be installed as shown be]ow.
m
• I • I I I
A
• i • • i •
Front of Range
I-] Orifice Spuds for Converting to Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, with the letter "N"
underneath denoting the location on the range
where it is to be installed as shown below.
Front of Range
(continued next page)
41