Level The Range - GE Appliances CS980 Owner's Manual & Installation Instructions

Installation Instructions
INSTALL THE RANGE
Bq
REPLACE THE WIRE COVER
Replace the wire cover on the range back by
sliding its right edge under the retaining tab
and replacing the two screws removed earlier.
Make sure that no wires are pinched between the
cover and the range back.
2 screws
to replace
wire cover
\
Back of range
ANTI-TIP DEVICE INSTALLATION
An Anti-Tip bracket is supplied with instructions
for installation in a variety of locations. The
instructions include all necessary information
to complete the installation. Read the Safety
Instructions and the instructions that fit your
situation before beginning installation.
Attachment to Wall or Floor
Bracket
JScrew must ente_
__Jwood or concrete
Wall Sill Plate
Screw must enter wood
WARNING:
. Range must be secured with an approved Anti-Tip
device.
, Unless properly installed, the range could be tipped
by you or a child standing, sitting or leaning on an
open door.
. After installing the Anti-Tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
, This range has been designed to meet all recognized
industry tip standards for all normal conditions.
, The use of this device does not preclude tipping
of the range when not properly installed.
, If the Anti-Tip device supplied with the range does
not fit this application, use the universal Anti-Tip
device WB02K10254.
| LEVEL THE RANGE
[]
Install the oven racks in the oven and position
the range where it will be installed.
Check for levelness by
placing a spirit level or a
cup, partially filled with Spirit
level
water, on one of the oven
racks. If using a spirit level,
take two readings-with
the level placed diagonally
first in one direction and then the other.
E1
The rear leveling legs must be adjusted prior
to moving the range into position. They can
be adjusted from the bottom at the back
of the range.
Adjust from
the bottom
back of range
(warming X
drawer models)
J
e , _ ® e
i_,:, _ _e _--_ _ 1 range
i_ .j_ ,Leg ii°#j
__ rlevele r ',.1
Lc_wer /
--_-_range
Back of range
El
El
El
Use an open-end or adjustable wrench to
adjust the leveling legs until the range is level.
Replace the drawer or panel.
After the range is level, slide the range away
from the wall so that the Anti-Tip device can be
installed.
45