Clock And Timer - GE Appliances CS980 Owner's Manual & Installation Instructions

Using the clock and timer. GEAppliances.c
Not all features are on all models.
Make sure the clock is set to the
correct time of day.
To Set the Clock
The clock must be set to the correct time of day
for the automatic oven timing functions to work
properly. The time of day cannot be changed
during u timed baking or self-cleaning cycle.
[Z] Touch the CLOCKpad.
[] Touch the number pads.
Touch the number pads the same way you
read them. Forexample, to set 12:34,touch the
number pads 1, 2, 3 and 4 in that order.
If number pads are not touched within one
minute after you touch the CLOCK pad, the
display reverts to the original setting. If this
happens, touch the CLOCK pad and reenter
the time of day.
[] Touch the STARTpad until the time of day
shows in the display. This enters the time
and starts the clock.
To check the time of day when the display is
showing other information, simply touch the
CLOCK pad. Thetime of day shows until another
pad is touched.
®®®®®
®®®®®
The timer is a minute timer only.
The CLEAR/OFF pad does not affect
the timer.
To Set the Timer
The timer does not control oven operations.
The maximum setting on the timer is 9 hours
and 59 minutes.
Touch the KITCHENTIMERON/OFF pad.
Touch the number pads until the amount
of time you want shows in the display. The
maximum number of minutes that can be
entered is 60.To set additional time, you
will need to set it by hours and minutes.
For example, to enter 1 hour and 30
minutes, touch 1, 3 and 0 in that order.
Ifyou make a mistake, press the KITCHEN
TIMERON/OFFpad and begin again.
@ Touch the STARTpad. After pressing the
STARTpad, SET disappears; this tells you
the time is counting down, although the
display does not change until one minute
has passed.
%
When the timer reaches :00, the control
will beep 3 times followed by one beep
every 6 seconds until the KITCHENTIMER
ON/OFF pad is touched.
The 6-second tone can be canceled by following
the steps in the Special features
of your upper oven control section under Tones
at the End of a Timed Cycle.
To Reset the Timer
If the display is still showing the time remaining,
you may change it by touching the KITCHEN
TIMERON/OFF pad; then touch the number
pads until the time you want appears in the
display.
If the remaining time is not in the display
(clock, delay start or cooking time are in the
display),recall the remaining time by touching
the KITCHENTIMERON/OFF pad and then
touching the number pads to enter the new
time you want.
To Cancel the Timer
Touch the KITCHENTIMERON/OFF pad twice.
Power Outage
I1:aflashing time is in the display,you have
experienced a power failure. Resetthe clock.
To reset the clock, touch the CLOCKpad.
Enterthe correct time of day by touching the
appropriate number pads. Touch the START
pad.
17